Universal Fighting Engine Forum Universal Fighting Engine (UFE), a fighting game toolkit for Unity 3D |
You are not logged in. Please login or register.
Universal Fighting Engine Forum → General → My blocking dont work
Character doesn't transit to block animation when he goes back and if he gets hit he receives full damage. I tried Auto Block and Hold Back block and they didn't work. I finally understood the blocking area when you setup Active Frames (it must be bigger than hurtbox and occupy more frames), but it didn't help.
Share
Make sure the "blockable area" is set to at least a frame before your active hits begin. Then, make sure you have the proper values setup match the the character's current state.
I figured it out)) For those who have similar issue - The blocking are must be the same as your hits (hurt boxes) but a little bigger and start a few frames earlier. Main reason for it is that it covers your hurt collider, and if opponent blocks - it triggers a block on hit animation. And don`t forget to set up the body part of the Blocking area - that was my issue, after tuto I don't understand fully what it does.
Share
Universal Fighting Engine Forum → General → My blocking dont work
Powered by PunBB, supported by Informer Technologies, Inc.