• Registered: 2014-06-06
  • Posts: 59
  • User Karma: 30

Topic: Animation issue

I created a two hit spinning attack for my character, and it works fine when I preview just the animation.

But when I try to make a move file, the animation in cut in half.  It's a 30 frame animation where only the first 15 play when creating the Move File.

What would cause this?

Share

Thumbs up Thumbs down

2 Reply by StriderSpinel (edited by StriderSpinel 2016-03-11 01:55:20)

  • From: Mexico
  • Registered: 2015-01-10
  • Posts: 434
  • User Karma: 303

Re: Animation issue

in the animations section of your character does the animation bar cover all the 30 frames of your anim? some times it end before and the anim doesn't play at full

http://s5.postimg.org/46kivppo5/Untitled_1.jpg

Me encontraste en un negro camino como un peregrino sin rumbo ni fe, pero la luz de tus ojos divinos cambió mi suerte por dicha y placer.

StriderSpinel's Website

Share

Thumbs up Thumbs down

  • Registered: 2014-06-06
  • Posts: 59
  • User Karma: 30

Re: Animation issue

StriderSpinel wrote:

in the animations section of your character does the animation bar cover all the 30 frames of your anim? some times it end before and the anim doesn't play at full

http://s5.postimg.org/46kivppo5/Untitled_1.jpg

It does.  It's cut in half when I do a "Move File" with that animation.

I tried it in UFE 1.6 and it works perfectly.

UFE 1.7 is where it does this.

Share

Thumbs up Thumbs down